Examine the diagram below:

You attempt to make a Telnet connection from PC1 to the switch connected to the Web server, but the
connection fails. After making a console connection to the switch connected to the Web server and executing
the show run command, you see the following information:

Which value is NOT correct?

A.
the default gateway

B.
the VLAN number

C.
the password

D.
the login command

Explanation:
The switch is connected to the F0/0/ interface on the router R1. The address of Fa0/0 should be the default
gateway for the switch. This means it should be 58.59.6.4 rather than 192.168.5.1.
The VLAN number is correct. The IP address of a switch is set on the VLAN 1 interface of the switch.
The password can be anything you desire, so that is correct.
The login command is correct. This command instructs the switch to prompt for a password. Since there is a
password configured, this will not prevent a connection to the switch.
Objective:
Infrastructure Management
Sub-Objective:
Configure and verify device management