Which Cisco IOS command would produce the preceding menu-based prompt for additional information?

A.
tracert 10.10.10.1

B.
traceroute 12.1.10.2

C.
ping 10.10.10.1

D.
ping

Explanation:
This menu-based prompt for additional information shown would be generated by the Cisco IOS ping command
when issued without a target IP address. This is also known as issuing an extended ping. This command can
be issued on the router to test connectivity between two remote routers. To execute an extended ping, enter the
ping command from the privileged EXEC command line without specifying the target IP address. It takes the
command into configuration mode, where various parameters, including the destination and target IP
addresses, can be defined.
Note: You can only perform an extended ping at the privileged EXEC command line, while the normal ping
works in both user EXEC mode and privileged EXEC mode.
The tracert command is incorrect because the tracert command is used by Microsoft Windows operating
systems, not Cisco devices. This command cannot be run via the Cisco IOS command line interface. However,
Microsoft’s tracert utility is similar to Cisco’s traceroute utility, which is to test the connectivity or “reachability” of
a network device or host. The tracert command uses Internet Control Message Protocol (ICMP) to list all of the
‘hops” or routers traversed to a destination.
The traceroute command is incorrect because this command uses Internet Control Message Protocol (ICMP)
to list all of the ‘hops” or routers traversed to a destination. It is also used to find routing loops or errors within a
network.
The ping 10.10.10.1 command is incorrect because you when you issue this command you will either receive a
reply from the destination or a destination unreachable message. It will not prompt for additional information as
shown
Objective:
Routing Fundamentals
Sub-Objective:
Configure, verify, and troubleshoot IPv4 and IPv6 static routing

Cisco > Cisco IOS Command Fundamentals Reference, Release 12.4 > ping
Cisco > Tech Notes > Using the Extended ping and Extended traceroute Commands > Document ID: 13730 >
The Extended ping Command
Cisco Documentation > Internetwork Troubleshooting Handbook > Troubleshooting TCP/IP