You connect Ethernet Port A on a Cisco TelePresence MCU 5300 Series device to the network. The device is
currently using the default settings. A DHCP server exists on the network.Which of the following will be displayed when you issue the status command?

A.
The default static IPv4 address will be displayed.

B.
The default static IPv6 address will be displayed.

C.
A dynamic IPv4 address will be displayed.

D.
A dynamic IPv4 address and a dynamic IPv6 address will be displayed.

E.
No address will be displayed.

Explanation:
A dynamic IPv4 address will be displayed when you issue the status command on the Cisco TelePresence
multipoint control unit (MCU) 5300 Series device. By default, Ethernet Port A is configured to use a dynamically
assigned IPv4 address from a Dynamic Host Configuration Protocol (DHCP) server. Although IPv6 addressing
is disabled by default, the MCU supports both IPv4 and IPv6 addressing.
To configure Ethernet Port A to use a static IPv4 address on Ethernet Port A, you should issue the static A ipaddress net-mask [default-gateway] command. To configure Ethernet Port A to receive an IPv4 address from a
DHCP server, you should issue the dhcp -4 A command.

Cisco: Cisco TelePresence MCU 5300 Series: Getting started (PDF)