PrepAway - Latest Free Exam Questions & Answers

Which of the following commands or command sets should …

Which of the following commands or command sets should you issue to configure a Cisco TelePresence
System 1000 with IP address 192.168.1.43, subnet mask 255.255.255.0, and default gateway 192.168.1.1?

PrepAway - Latest Free Exam Questions & Answers

A.
static 192.168.1.43 255.255.255.0 192.168.1.1

B.
ip address 192.168.1.43 255.255.255.0 192.168.1.1

C.
set network ip static 192.168.1.43 255.255.255.0 192.168.1.1

D.
xConfiguration Network 1 IPv4 Address: “192.168.1.43”
xConfiguration Network 1 IPv4 SubnetMask: “255.255.255.0”
xConfiguration Network 1 IPv4 Gateway: “192.168.1.1”

E.
ip address 192.168.1.43 255.255.255.0
ip defaultgateway 192.168.1.1

Explanation:
You should issue the set network ip static 192.168.1.43 255.255.255.0 192.168.1.1 command. The syntax of
the set network ip static command is set network ip static ip-address subnet-mask default-gateway
[dnsaddress1] [dnsaddress2] [domain]. After you configure the static IP address, the Cisco TelePresence
System (CTS) 1000 will automatically restart.
You can also configure a static IP address on a CTS 1000 by using the web interface. To configure a static IP
address by using the web interface, navigate to Configuration > IP Settings, change DHCP Enabled to No, and
configure the IP address, subnet mask, and default gateway fields.
You should not issue the static 192.168.1.43 255.255.255.0 192.168.1.1 command. The static command
configures a static IP address for a port on the Cisco TelePresence multipoint control unit (MCU) 5300. The
syntax of the static command is static port ip-address subnet-mask [default-gateway], where port is A for Port A
or B for Port B.
You should not issue the ip address 192.168.1.43 255.255.255.0 192.168.1.1command. The ip address
command is not valid on a CTS 1000.
You should not issue the following command set:
xConfiguration Network 1 IPv4 Address: “192.168.1.43”
xConfiguration Network 1 IPv4 SubnetMask: “255.255.255.0”
xConfiguration Network 1 IPv4 Gateway: “192.168.1.1”
You would issue these commands to configure a static IP address on a CTS Codec, such as the C40 or C60.
You should not issue the following command set:
ip address 192.168.1.43 255.255.255.0
ip defaultgateway 192.168.1.1
This command set is similar to the IP address configuration of a Cisco router or switch. However, these
commands are not valid on a CTS 1000.

Cisco: Configuring the Cisco TelePresence System: Configuring a Static IP Address for Networks That Do Not
Use DHCP


Leave a Reply