Which of the following commands should you issue to dynamically configure an IP address on Ethernet Port A
on a Cisco TelePresence MCU 5300 Series device?

A.
dhcp

B.
dns

C.
ethertype

D.
static

E.
status

Explanation:
You should issue the dhcp command to dynamically configure an IP address on Ethernet Port A on a Cisco
TelePresence multipoint control unit (MCU) 5300 Series device. For example, to dynamically assign an IPv4
address to Port A, you should issue the dhcp -4 A command. Dynamic addressing is provided by a Dynamic
Host Configuration Protocol (DHCP) server.
You should issue the static command to manually configure an IP address on Ethernet Port A. The syntax of
the static command is static port ip-address net-mask [default-gateway]. For example, to assign address
10.20.30.40/24 on Port A with default gateway 10.20.30.1, you should issue the static A 10.20.30.40
255.255.255.0 10.20.30.1command.
You should issue the dns command to statically configure a Domain Name System (DNS) server address. The
syntax of the dns command is dns primary-server-address[secondary-server-address] [domain].
You should issue the ethertype command to configure speed and duplex settings on Ethernet Port A. To
configure Port A to use autosensing mode, you should issue the ethertype A auto command. To manually
configure Port A with speed or duplex settings, you should issue the ethertype A [10 | 100] [half | full] command.
You should issue the status command to display the current configuration and status of the Ethernet ports.
Speed, duplex, and static or dynamic IP address information is displayed by the status command.

Cisco: Cisco TelePresence MCU 5300 Series, Getting started (PDF)