Your network has a router named Router1 that provides access to the Internet. You have a server
named Server1 that runs Windows Server 2012 R2. Server1 to use Router1 as the default gateway.
A new router named Router2 is added to the network. Router2 provides access to the Internet. The
IP address of the internal interface on Router2 is 10.1.14.2S4.
You need to configure Server1 to use Router2 to connect to the Internet if Router1 fails.
What should you do on Server1?
A.
Add a route for 10.1.14.0/24 that uses 10.1.14.254 as the gateway and set the metric to 1.
B.
Add 10.1.14.254 as a gateway and set the metric to 1.
C.
Add a route for 10.1.14.0/24 that uses 10.1.14.254 as the gateway and set the metric to 500.
D.
Add 10.1.14.254 as a gateway and set the metric to 500.
Explanation:
To configure the Automatic Metric feature:
1. In Control Panel, double-click Network Connections.
2. Right-click a network interface, and then click Properties.
3. Click Internet Protocol (TCP/IP), and then click Properties.
4. On the General tab, click Advanced.
5. To specify a metric, on the IP Settings tab, click to clear the Automatic metric check box, and then
enter the metric that you want in the Interface Metric field.
To manually add routes for IPv4
Open the Command Prompt window by clicking the Start button Picture of the Start button. In the
search box, type Command Prompt, and then, in the list of results, click Command Prompt.
At the command prompt, type route -p add [destination] [mask <netmask>] [gateway] [metric
<metric>] [if <interface>].
Wrong as usual. Right one is D.
0
0
The answer can’t be C because its sets a GW to a specific address scope, its will go through router2 only when you look for address in the area of 10.1.14.0/24.
So the correct answer is D.
http://www.aiotestking.com/microsoft/you-need-to-configure-server1-to-use-router2-to-connect-to-the-internet-if-router1-fails/
0
0
Clearly D.
0
0
Correct answer= D
0
0