Refer to the exhibit.
This network is configured with PIM, and the RPF check has failed toward the multicast source.
Which two configuration changes must you make to router R3 to enable the RPF check to pass?
(Choose two.)
A.
Configure a static multicast route to the multicast source through the tunnel interface.
B.
Configure a static multicast route to the multicast source LAN through the tunnel interface.
C.
Configure a static multicast route to the multicast source LAN through the Ethernet interface.
D.
Remove the command ip prim bidir-enable from the R3 configuration.
doesn’t make sense. why would you use a host route AND and route to its subnet?
0
0