PrepAway - Latest Free Exam Questions & Answers

how many neighbors will be seen in the EIGRPv6 neighbor table on this IPv6-only router?

Refer to the exhibit.

Assuming that the peer is configured correctly and the interface is up, how many neighbors will be
seen in the EIGRPv6 neighbor table on this IPv6-only router?

PrepAway - Latest Free Exam Questions & Answers

A.
one neighbor, which will use a local router-id of 6010. AB8. . /64

B.
one neighbor, which will use a local router-id of 6020. AB8. . /64

C.
none, because EIGRPv6 only supports authenticated peers

D.
none, because of the mismatch of timers

E.
none, because there is no EIGRP router ID configured

18 Comments on “how many neighbors will be seen in the EIGRPv6 neighbor table on this IPv6-only router?

    1. 2ielony-ludek says:

      R1(config-rtr)#do sh ipv6 proto
      IPv6 Routing Protocol is “ND”
      IPv6 Routing Protocol is “connected”
      IPv6 Routing Protocol is “eigrp 50”
      EIGRP-IPv6 Protocol for AS(50)
      […]
      Router-ID: No usable Router-ID found
      […]
      Interfaces:
      Redistribution:
      None
      R1(config-rtr)#

      After providing router-ID the configured interface appears in “sh ipv6 proto” and a neighborhood appears as well.




      0



      0

Leave a Reply