PrepAway - Latest Free Exam Questions & Answers

which device will be active when sglondon_1 is back up and running? Why?

In the following cluster configuration; if you reboot sglondon_1 which device will be active when
sglondon_1 is back up and running? Why?

PrepAway - Latest Free Exam Questions & Answers

A.
sglondon_1 because it the first configured object with the lowest IP.

B.
sglondon_2 because sglondon_1 has highest IP.

C.
sglondon_1, because it is up again, sglondon_2 took over during reboot.

D.
sglondon_2 because it has highest priority.

21 Comments on “which device will be active when sglondon_1 is back up and running? Why?

  1. h3r3tic says:

    The graphic should show the cluster members listing in the cluster object, the first listed is the highest priority member. The listing must go:

    sglondon_2
    sglondon_1

    Also – the setting to maintain highest priority member must be configured. Other possibilities are to maintain current member.




    0



    0
    1. Chris says:

      I passed during the last week. in my exam, i got this question. there was no Image or anything like “following configuration” it was exactly like above.

      I guess this is not needed as three of the answers do not make sense anyways. sort of “this is not how it works in General”

      i think the question can also be read as “how is the next-active member Chosen if the currently-active member fails”

      i think priority is correct. not sure if there is any lowest/highest IP check in the decision




      0



      0
  2. Imran says:

    Answer is D

    The Security Gateway with the highest available priority becomes the new master. The range of valid values 1 to 254. The default setting is 100.

    Note – If the effective priority for the current master and backup are the same, the gateway with the highest IP address becomes the master.

    Upon the recovery of a member with a higher priority, the role of the active member may or may not be switched back to that member, depending on the user configuration i-e
    Maintain Current Active Security Gateway
    OR
    Switch to Higher Priority Security Gateway




    0



    0
  3. Catalin says:

    I passed today with 93/100 in Bucharest/Romania (total of 89 questions).

    There were 7-8 new questions that are not on this site, some of them from two new topics I did not see here, Threat Prevention (2 questions) and IPS(2 questions).

    For all the questions I had to choose one correct answer out of 4 (four) options. NO command writing questions.

    All the best for everybody!




    0



    0
  4. dota2forever says:

    Hey,

    i passed the exam this week. 80-90% of questions were exactlly the same as here in this dump. I had few questions about IPS but they were easy.

    Good luck.




    0



    0
  5. teo says:

    Hi Guys,
    are enough google dumps on PL?
    Ore is better buy the complete one?
    Because there are a lot of different question.. (around 628 of PL-Free vs 752 of PL)

    Thanks




    0



    0
  6. Correct Answer: D
    Dumps4download.com is famous and best for exam study material. If you need to pass your Check Point Security Expert R77 156-315.77 question answers in first attempt then visit Dumps4download and get 156-315.77 dumps download questions with actual answers. You can get any type of exam dumps from Dumps4download.com Preparation of certificated exam in a short time is tough that’s why we helps people and provide them exam dumps. https://www.dumps4download.com/156-315.77-dumps.html




    0



    0

Leave a Reply