PrepAway - Latest Free Exam Questions & Answers

What command should you use to identify the possible cause?

A customer called to report one cluster member’s status as Down. What command should you use
to identify the possible cause?

PrepAway - Latest Free Exam Questions & Answers

A.
tcpdump/snoop

B.
cphaprob list

C.
fw ctl pstat

D.
fw ctl debug -m cluster + forward

4 Comments on “What command should you use to identify the possible cause?

  1. imran says:

    B is correct.

    ‘C’ will show you the sync status only but will not tell what the problem is. with ‘B’ you can atleast see the status of a critical device

    firewall# cphaprob list

    Built-in Devices:

    Device Name: Interface Active Check
    Current state: OK

    Device Name: Recovery Delay
    Current state: OK

    Registered Devices:

    Device Name: Synchronization
    Registration number: 0
    Timeout: none
    Current state: OK
    Time since last report: 1.01244e+06 sec

    Device Name: Filter
    Registration number: 1
    Timeout: none
    Current state: OK
    Time since last report: 1.01244e+06 sec

    Device Name: routed
    Registration number: 2
    Timeout: none
    Current state: OK
    Time since last report: 1.01243e+06 sec

    Device Name: cphad
    Registration number: 3
    Timeout: none
    Current state: OK
    Time since last report: 767668 sec

    Device Name: fwd
    Registration number: 4
    Timeout: none
    Current state: OK
    Time since last report: 767778 sec




    0



    0

Leave a Reply