Which CLI tool helps on verifying proper ClusterXL sync?
A.
fw stat
B.
fw ctl sync
C.
fw ctl pstat
D.
cphaprob stat
Get 50% Discount on All Your Purchases
at PrepAway.com - Latest Exam Questions
This is ONE TIME OFFER
50%
Isn’t answer D?
0
0
no cpahprob stat (actually state) Shows you the state of the Cluster members load sharing mode
like that
Cluster mode: Load sharing (Multicast)
Number Unique Address State
1 (local) 30.0.0.1 active
2 30.0.0.2 active
fw ctl pstat Displays Information about the sync
Sync:
Version: new
Status: Able to Send/Receive sync packets
Sync packets sent:
total : 466729198, retransmitted :241305, retrans reqs : 6089, acks : 809
Sync packets received:
total : 77283541, were queued : 6715, dropped by net : 6079
retrans reqs : 37462, received 221 acks
retrans reqs for illegal seq : 2
dropped updates as a result of sync overload: 3
Delta Sync memory usage: currently using XX KB mem
Callback statistics: handled 165 cb, average delay : 3, max delay : 34
Number of Pending packets currently held: 1
Packets released due to timeout: 18
0
0
cphaprob state and fw ctl pstat both do…at least, if you were troubleshooting you would check both commands.
fw ctl pstat shows more information, but won’t show you if you are at Active/Standby or something different, so the answer is probably better suited to D
reason: if you had a scenario of Active/Down and you issued the fw ctl pstat on the Active member, everything would appear ok. cphaprob state issued on that same member would immediately tell you there was a problem by displaying the other member as Down…
0
0
Maybe D ist the better answer to the following question:
Which CLI tool gives information about a cluster concerning readiness for failover?
For proper ClusterXL sync prefer answer C.
0
0
Yes, I agree it is answer D and not C.
0
0
No it’s C 🙂
1st: ‘cphaprob stat’ is technically NOT a command that exist, if it was ‘cphaprob state’ then that would be okay
2nd: ‘cphaprob state’ displays the health of the Cluster, if you want ot verify sync traffic and such, better use ‘fw ctl pstat’
0
0
I think answer is C
because can undersand the packet count of sync interfaces which actively works or not.
0
0
Correct answer is C:
Please refer to the below link
https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk34476
0
0
C. fw ctl pstat
0
0