You are using IPv6, and would like to configure EIGRPv6. Which three of these correctly describe
how you can perform this configuration? (Choose three.)

A.
EIGRP for IPv6 is directly configured on the interfaces over which it runs.

B.
EIGRP for IPv6 is not configured on the interfaces over which it runs, but if a user uses
passive-interface configuration, EIGRP for IPv6 needs to be configured on the interface that is
made passive.

C.
There is a network statement configuration in EIGRP for IPv6, the same as for IPv4.

D.
There is no network statement configuration in EIGRP for IPv6.

E.
When a user uses a passive-interface configuration, EIGRP for IPv6 does not need to be
configured on the interface that is made passive.

F.
When a user uses a non-passive-interface configuration, EIGRP for IPv6 does not need to be
configured on the interface that is made passive

Explanation:
Restrictions for Implementing EIGRP for IPv6:
This section lists ways in which EIGRP for IPv6 differs from EIGRP IPv4 as well as EIGRP for
IPv6 restrictions.
•
EIGRP for IPv6 is directly configured on the interfaces over which it runs. This feature allows

EIGRP for IPv6 to be configured without the use of a global IPv6 address. There is no network
statement in EIGRP for IPv6.
In per-interface configuration at system startup, if EIGRP has been configured on an interface,
then the EIGRP protocol may start running before any EIGRP router mode commands have been
executed.
•
An EIGRP for IPv6 protocol instance requires a router ID before it can start running.
•
EIGRP for IPv6 has a shutdown feature. The routing process should be in “no shutdown” mode in
order to start running.
•
When a user uses passive-interface configuration, EIGRP for IPv6 does not need to be
configured on the interface that is made passive.
•
EIGRP for IPv6 provides route filtering using the distribute-list prefix-list command. Use of the
routE.map command is not supported for route filtering with a distribute list.