Refer to the Exhibit:

The user who is connected to interface FastEthernet 0/1 is on VLAN 10 and cannot access network resources.
On the basis of the information in the exhibit, which command sequence would correct the problem?

A.
SW1(config)# vlan 10
SW1(config-vlan)# no shut

B.
SW1(config)# interface fastethernet 0/1
SW1(config-if)# switchport mode access
SW1(config-if)# switchport access vlan 10

C.
SW1(config)# interface fastethernet 0/1
SW1(config-if)# switchport mode access

D.
SW1(config)# vlan 10
SW1(config-vlan)# state active

E.
SW1(config)# interface fastethernet 0/1
SW1(config-if)# no shut

Explanation:

In Exhibit Operation Mode is down, it means interface is in down state. Just bring into up state using no shutdown command