PrepAway - Latest Free Exam Questions & Answers

Which command sequence would configure interface FastEthernet 0/13 as displayed in Figure 2?

Refer to the exhibit.

The switchport output in Figure 1 displays the default settings of interface
FastEthernet 0/13 on switch SW1. Figure 2 displays the desired interface settings. Which
command sequence would configure interface FastEthernet 0/13 as displayed in Figure 2?

PrepAway - Latest Free Exam Questions & Answers

A.
SW1(config-if)# switchport trunk encapsulation dot1q SW1(config-if)# switchport mode
trunk
SW1(config-if)# switchport trunk native DATA SW1(config-if)# switchport trunk allowed vlan
1, 10, 20

B.
SW1(config-if)# switchport trunk encapsulation dot1q SW1(config-if)# switchport mode
dynamic auto SW1(config-if)# switchport trunk native DATA SW1(config-if)# witchport trunk
allowed vlan add 1, 10, 20

C.
SW1(config-if)# switchport trunk encapsulation dot1q SW1(config-if)# switchport mode
dynamic
desirable SW1(config-if)# switchport trunk native vlan DATA SW1(config-if)# switchport trunk
allowed vlan 1, 10, 20

D.
SW1(config-if)# switchport trunk encapsulation dot1q SW1(config-if)# switchport mode
dynamic
desirable SW1(config-if)# switchport trunk native vlan 10 SW1(config-if)# switchport trunk
allowed vlan 1, 10, 20

E.
SW1(config-if)# switchport trunk encapsulation dot1q SW1(config-if)# switchport mode
dynamic
Desirable SW1(config-if)# switchport trunk native vlan 10

Explanation:
According to the exhibit, the Operational Mode is down meaning that the port has been
administratively shut down. To work properly the Operational Mode should be in up. So use
no shutdown command to bring interface fastethernet 0/1 will fix this issue.

2 Comments on “Which command sequence would configure interface FastEthernet 0/13 as displayed in Figure 2?”

  2. Leonid says:

    The explanation relates to the previous question. The explanation for this question next.
    To change the negotiation trunk type set
    SW1(config-if)#switchport mode dynamic desirable
    To change the encapsulation type set
    SW1(config-if)#switchport trunk encapsulation dot1q
    To change the native vlan set
    SW1(config-if)#switchport trunk native vlan 10
    To change the allowed vlans set
    SW1(config-if)#switchport trunk allowed vlan 1, 10, 20




    0



    0

Leave a Reply