What three tasks will a network administrator perform to successfully configure Hot Standby
Routing Protocol (HSRP)? (Choose three.)

A.
Define the encapsulation type

B.
Define the standby router

C.
Define the standby IP address

D.
Enable the standby mode

E.
Enable HSRP

Explanation:
The basic steps to configure HSRP are as follows:
1. Define the standby IP address. This will be shared across the HSRP routers and will be
used as the default GW for hosts.
2. Define the standby router – This is done by assigning the priority level of each router. The
default value is 100 and highest one will be the active router.
3. Enable HSRP.