You have configured a Cisco Catalyst switch to perform Layer 3 routing via an SVI and have
assigned that interface to VLAN 20. To check the status of the SVI, you issue the show
interfaces vlan 20 command at the CLI prompt. You see from the output display that the
interface is in an “up/up” state. What must be true in an SVI configuration to bring the VLAN
and line protocol up?

A.
The port must be physically connected to another Layer 3 device.

B.
At least one port in VLAN 20 must be active.

C.
The Layer 3 routing protocol must be operational and receiving routing updates from
neighboring peer devices.

D.
Because this is a virtual interface, the operational status will always be in an “up/up”
state.