HOTSPOT
Your company has four offices. The offices are located in Montreal, Seattle, Sydney, and New York.
The network contains an Active Directory domain named contoso.com. The domain contains a
server named Server2 that runs Windows Server 2012 R2. Server2 has the DHCP Server server role
installed.
All client computers obtain their IPv4 and IPv6 addresses from DHCP.
You need to ensure that Network Access Protection (NAP) enforcement for DHCP applies to all of the
client computers except for the client computers in the New York office.
Which two nodes should you configure? To answer, select the appropriate two nodes in the answer
area.
Answer: 
I think the two nodes are: IPv4 – Scope…New York and IPv6 – Scope…New York. The DHCP assigns IPv4 and IPv6 addresses
0
0
The answer is correct, as Ric says, NAP is not compatible with IPv6, so you need to go into the IPv4 Properties and ‘Enable on all scopes’ on the Network Access Protection tab. Then on the Contoso New York tab, go into Properties and check ‘Disable for this scope’
0
0
I was completely confused by this question. Thanks for the explanation!
0
0
answer is right. NAP is not compatible with IPv6
0
0