What command changes the standard 10 watts of power to the required 7 watts to the powered ports on a Cisco 6000 series switch?

A.
set power allocation 7

B.
set power allocation 7000

C.
set inlinepower defaultallocation 7

D.
set inlinepower defaultallocation 7000

Explanation:
setinlinepower defaultallocation
To set the default power allocation for a port, use the set inlinepower defaultallocation command.
set inlinepower defaultallocation value
Syntax Description
value Default power allocation; valid values
are from 4000 to 15400 milliwatts.
Defaults
The default is 15400 milliwatts.
Command Types
Switch command.
Command Modes
Privileged.
Usage Guidelines
The set inlinepower defaultallocation command is global and only affects Cisco IP phones.
Caution
The set inlinepower defaultallocation command can be harmful when there is not enough power in the system to bring up all connected inline power devices. If you set a small value for the power allocation, all connected inline power devices initially will be powered up. However, after receiving CDP messages, the system will learn that devices are consuming more power and deny power to some of the ports. Setting a small value might also result in the overdrawing of power for some time with unanticipated results, such as hardware failures and unexpected resets.
7000 milliwatts is the maximum power supported for these modules: WS-X6148-RJ21V, WS-X6148-RJ45V, WS-X6348-RJ21V, and WS-X6348-RJ45V.
Examples
This example shows how to set the default power allocation to 9500 milliwatts:
Console> (enable) set inlinepower defaultallocation 9500Default inline power allocation set to 9500 mWatt per applicable port.Console> (enable)