You have a server named LON-DC1 that runs Windows Server 2012 R2. An iSCSI virtual disk named
VirtualiSCSI1.vhd exists on LON-DC1 as shown in the exhibit. (Click the Exhibit button.)
You create a new iSCSI virtual disk named VirtualiSCSI2.vhd by using the existing itgt iSCSI target.
VirtualiSCSIl.vhd is removed from LON-DC1.
You need to assign VirtualiSCSI2.vhd a logical unit value of 0.
What should you do?
A.
Modify the properties of the itgt ISCSI target.
B.
Modify the properties of the VirtualiSCSI2.vhd iSCSI virtual disk.
C.
Run the Set-VirtualDisk cmdlet and specify the -Uniqueld parameter.
D.
Run the iscsicli command and specify the reportluns parameter.
Explanation:
The virtual disk has the option to change the lun ID, no other option available in the answers appear
to allow this change.
Note: Logical unit numbers (LUNs) created on an iSCSI disk storage subsystem are not directly
assigned to a server. For iSCSI, LUNs are assigned to logical entities called targets.
it should be D
0
1
Tamer, why would you say that? D only provides a report of the lun #. It does not allow you to change it, which is what the question is asking.
The answer is correct: B.
1
0
properties dialog box of the iSCSI virtual disk allows u to modify the LUN value assigned to the disk
0
0
It can also be done with the powershell command: Add-IscsiVirtualDiskTargetMapping -Lun.
There’s another version of this question which the correct option would be the one i’m poiting.
0
0
Correct. When there are 2 very good answers, almost always go for the one with Powershell. It’s just typical of what MS wants.
0
0
Add-IscsiVirtualDiskTargetMapping: Assigns a virtual disk to an iSCSI target.
0
0