Your network contains an Active Directory domain named contoso.com. The domain contains three
servers named Server1, Server2, and Server3 that run Windows Server 2012 R2. All three servers have
the Hyper-V server role installed and the Failover Clustering feature installed.
Server1 and Server2 are nodes in a failover cluster named Cluster1. Several highly available virtual
machines run on Cluster1. Cluster1 has that Hyper-V Replica Broker role installed. The Hyper-V Replica
Broker currently runs on Server1.
Server3 currently has no virtual machines.
You need to configure Cluster1 to be a replica server for Server3 and Server3 to be a replica server for
Cluster1.
Which two tools should you use? {Each correct answer presents part of the solution. Choose two.)

A.
The Hyper-V Manager console connected to Server3

B.
The Failover Cluster Manager console connected to Server3

C.
The Hyper-V Manager console connected to Server1.

D.
The Failover Cluster Manager console connected to Cluster1

E.
The Hyper-V Manager console connected to Server2

Explanation:
Steps:
Install the Replica Broker Hyper-v “role” configure replication on Server 3 in Hyper-V manager and
mention the cluster (that’s why a replica broker is needed) configure replication on Cluster 1 using the
failover cluster manager.
Using Hyper-V Replica in a failover cluster The configuration steps previously described Apply to VMs
that are not hosted in a failover cluster. However, you might want to provide an offsite replica VM for a
clustered VM. In this scenario, you would provide two levels of fault tolerance. The failover cluster is
used to provide local fault tolerance, for example, if a physical node fails within a functioning data
center. The offsite replica VM, on the other hand, could be used to recover only from sitelevel failures,for example, in case of a power outage, weather emergency, or natural disaster. The steps to configure a
replica VM for a clustered VM differ slightly from the normal configuration, but they aren’t complicated.
The first difference is that you begin by opening Failover Cluster Manager, not Hyper-V Manager. In
Failover Cluster Manager, you then have to add a failover cluster role named Hyper-V Replica Broker to
the cluster. (Remember, the word “role” is now used to describe a hosted service in a failover cluster.)
To add the Hyper-V Replica Broker role, right-click the Roles node in Failover Cluster Manager and select
Configure Role. This step opens the High Availability Wizard. In the High Availability Wizard, select
Hyper-V Replica Broker