One Comment on “Which two commands may be used when configuring an IP address for a Gigabit Ethernet interface?”

1. Flavio says:

   January 20, 2014 at 7:53 pm

   Correct:

   B.
   set interfaces ge-0/0/0.0 family inet address 10.1.1.1/24

   C.
   set interfaces ge-0/0/0 unit 0 family inet address 10.1.1.1/24

   How we can see below, if we type “set interface interface number”, there isn’t the address option :

   root@host# set interfaces em0 ?
   Possible completions:
   accounting-profile Accounting profile name
   + apply-groups Groups from which to inherit configuration data
   + apply-groups-except Don’t inherit configuration data from these groups
   description Text description of interface
   disable Disable this interface
   encapsulation Physical link-layer encapsulation
   gratuitous-arp-reply Enable gratuitous ARP reply
   > hold-time Hold time for link up and link down
   > layer2-policer Layer2 policing for interface
   link-mode Link operational mode
   mac Hardware MAC address
   mtu Maximum transmit packet size (256..9192)
   no-gratuitous-arp-reply Don’t enable gratuitous ARP reply
   no-gratuitous-arp-request Ignore gratuitous ARP request
   no-traps Don’t enable SNMP notifications on state changes
   > traceoptions Interface trace options
   traps Enable SNMP notifications on state changes
   > unit Logical interface
   vlan-tagging 802.1q VLAN tagging support

   
   
   
   0

   
   
   
   0