The exhibit shows R1 topology table to reach 192.168.1.0/24 network.
Which route(s) will be installed in routing table of R1 to reach network 192.168.1.0/24 after
configuring R1 with the following command?
Router(config-router)# variance 2

A.
R2 only

B.
R2 and R3

C.
R2 and R4

D.
R2, R3 and R4

Explanation:
EIGRP will only use equal-cost load-balancing feature even when the variance command is
used. However, if you use both the traffic-share min command and variance command, even
though traffic is sent over the minimum-cost path only, all feasible routes get installed into
the routing table, which decreases the convergence times