Which of the following are methods EIGRP uses to initially populate (seed) its EIGRP
topology table, before learning topology data from neighbors? (Choose two.)

A.
By adding all subnets listed by the show ip route connected command

B.
By adding the subnets of working interfaces over which static neighbors have been
defined

C.
By adding subnets redistributed on the local router from another routing source

D.
By adding all subnets listed by the show ip route static command

Explanation:
Other than the two listed correct answers, the local router also adds connected routes for
which the network command matches the corresponding interfaces, so it may not add all
connected routes. Also, EIGRP does not add static routes to the EIGRP topology table,
unless those routes are redistributed.