The partial output displayed in the exhibit is a result of what IOS command? (Click on the Exhibit(s) button.) A. switch# show running-config B. switch# show standby vlan1 active brief C. switch# show hsrp 1 D. switch# show standby Explanation: The command show standby produces the output displayed in the exhibit. This command displays information […]

You have configured three routers in HSRP group 10 to provide gateway redundancy for VLAN 56. Your intention was for Router 1 to be the active router in the group and for Router 3 to be the standby router. Furthermore, in the event that Router 1 became unavailable, resulting in Router 3 becoming active, you […]

Assuming that preempt is not configured, when does a router in an HSRP group assume the role of the active router for the group? A. A router in standby status will become the active router if it has a higher priority than the active router. B. A router in standby status will become the active […]

What attack technique can be used to force user traffic through an attacking device, causing a man-in-the-middle attack? A. VLAN hopping B. DHCP spoofing C. Rogue device D. MAC flooding Explanation: DHCP spoofing is an attack that can be used to force user traffic through an attacking device. This is accomplished by an attacker responding […]

You have configured switches A and B in a network. The gigabitethernet0/1 interface of switch A has HSRP enabled on it for VLAN 30. Switch A has a priority of 240 and switch B has a priority of 200 for the HSRP group. You want to ensure that if the gigabitethernet0/1 interface of switch A […]

What command would be used to display detailed information regarding VRRP groups on the switch? A. switch# show vrrp B. switch# show standby C. switch# show vrrp detail D. switch# show standby detail Explanation: The command that would display detailed information regarding VRRP groups on the switch is show vrrp. The information provided for each […]

What command disables 802.1x authentication on a port and permits traffic without authentication? A. dot1x port-control disable B. dot1x port-control force-unauthorized C. dot1x port-control auto D. dot1x port-control force-authorized Explanation: The command dot1x port-control force-authorized is used to disable 802.1x on a port and permit traffic without authentication. Dot1x ports are in one of two […]

Which command enables GLBP on an interface? A. glbp B. glbp 10 ip 192.168.1.1 C. standby mode glbp D. switchport mode glbp Explanation: The glbp ip interface configuration command enables Group Load Balancing Protocol (GLBP). The syntax for this command is as follows: switch(config-if)# glbp group-number ip ip-address The following example activates GLBP for group […]

What command would display a single line of information for each virtual gateway or virtual forwarder on a switch? A. switch# show glbp B. switch# show glbp brief C. switch# show standby D. switch# show standby brief Explanation: A brief single line view of virtual forwarder and virtual gateway information is provided with the command […]

What command provides the output shown in the exhibit? (Click on the Exhibit(s) button.) A. switch# show glbp B. switch# show standby C. switch# show glbp status D. switch# show standby brief Explanation: The command show glbp displays the output in the exhibit. This command displays detailed information about GLBP groups on the switch. In […]