Which highly available Edge design would provide high bandwidth and isolation to four application networks?
A.
Four Distributed Routers (standalone mode) with one Edge Services Gateway in Active/Standby mode.
B.
One Edge Services Gateway in ECMP mode.
C.
One distributed Router (in HA mode) with two Edge Services Gateways in ECMP mode.
D.
Four Distributed Routers (in HA mode) with one Edge Services Gateway in Active/Standby mode.
C
1
0
Yes C. The question is regarding the HA of Edge services so more than one ESG is required.
1
0
should be C
0
0
High available would mean an ESG in at least HA mode.
High bandwith means more than one ESG with ECMP enabled.
Isolation of four networks can be obtained with one DLR (in HA) mode.
Leaves C as the only viable solution
3
0
By the way, part of new 313Q VMWare 2V0-642 dumps are available here:
https://drive.google.com/open?id=0B-ob6L_QjGLpbVl3X1hXbUdteHc
Best Regards!
0
0
In order to provide isolation you need to deploy separate DLR. Answer C provide HA only in DLR. so, Answer D is closer to the question than C.
0
4
You can do isolation on one DLR. This is router so can route traffic between 4 isolated networks. Implementing D you will not achieve – high bandwidth.
So correct should be C
1
0
C is right
refer this pdf : https://www.vmware.com/content/dam/digitalmarketing/vmware/en/pdf/products/nsx/vmw-nsx-network-virtualization-design-guide.pdf
page 22, 76..
1
0
C is right, refer to comment of sanjay above.
0
0
Keep in mind the following caveats:
Cannot connect more than one DLR to any given VLAN or VXLAN.
https://docs.vmware.com/en/VMware-NSX-Data-Center-for-vSphere/6.3/com.vmware.nsx.troubleshooting.doc/GUID-F9E5A0A4-898A-4268-B73E-BDB9E360CA2E.html
Thats why D should be correct answer here.
0
1