Your network contains an Active Directory domain named adatum.com. The domain
contains a member server named L0N-DC1.L0N-DC1 runs Windows Server 2012 R2 and
has the DHCP Server server role installed.
The network contains 100 client computers and 50 IP phones. The computers and the
phones are from the same vendor.
You create an IPv4 scope that contains addresses from 172.16.0.1 to 172.16.1.254.
You need to ensure that the IP phones receive IP addresses in the range of 172.16.1.100 to
172.16.1.200. The solution must minimize administrative effort.
What should you create?
A.
Server level policies
B.
Reservations
C.
Filters
D.
Scope level policies
Explanation:
The scope is already in place.
Scope level policies are typically settings that only apply to that scope. They can also
overwrite a setting that was set at the server level.
References:
Training Guide: Installing and Configuring Windows Server 2012 R2, Chapter 6: Network
Administration, p.253
http://blogs.technet.com/b/teamdhcp/archive/2012/08/22/granular-dhcp-server-administration-using-dhcp-policies-in-windows-server-2012.aspx
Policies can be defined server wide or for a specific scope. A server wide policy – on the same lines as server wide option values – is applicable to all scopes on the DHCP server. A server wide policy however cannot have an IP address range associated with it.
Therefore Answer D: Scope level policies
0
0
B is possible but
The solution must minimize administrative effort
D is OK
1. Scope level policies and Conditions with MAK
but
The solution must minimize administrative effort
its possible
Desk phones: If the desk phones are Nortel IP phones, you can create a vendor Class named “Nortel phone” with data of the vendor class definition as “Nortel-i2004-A” on the DHCP server. Cisco IP phones also send a specific vendor class (for example, ‘Cisco Systems, Inc. IP Phone CP-7940G’ ) in the DHCP message.
v DHCP new vendor class Nortel-i2004-A
and dhcp scope policy with this new vendor class
minimum administrative effort
ANSWER D is OK
0
0