HOTSPOT
You have a server named LON-SVR1 that runs Windows Server 2012 R2. LON-SVR1 has
the Remote Access server role installed. LON-SVRl is located in the perimeter network.
The IPv4 routing table on LON-SVR1 is configured as shown in the following exhibit. (Click the Exhibit button.)
Your company purchases an additional router named Router1. Router1 has an interface that
connects to the perimeter network and an interface that connects to the Internet. The IP
address of the interface that connects to the perimeter network is 172.16.0.2.
You need to ensure that LON-SVR1 will route traffic to the Internet by using Router1 if the
current default gateway is unavailable.
How should you configure the static route on LON-SVR1?
To answer, select the appropriate static route in the answer area.
Answer: 
Explanation:
Metric: Specifies an integer cost metric (ranging from 1 to 9999) for the route, which is used
when choosing among multiple routes in the routing table that most closely match the
destination address of a packet being forwarded. The route with the lowest metric is chosen.
The metric can reflect the number of hops, the speed of the path, path reliability, path
throughput, or administrative properties.
A metric is a value that is assigned to an IP route for a particular network interface that
identifies the cost that is associated with using that route.
The metric that is assigned to specific default gateways can be configured independently for
each gateway. This setup enables a further level of control over the metric that is used for
the local routes.
I agree
metric 300 means that this route is 2nd
the first router has 257
Open Shortest Path First (OSPF) Metric value (OSPF Cost Value)
= lowest value is first accessed.
prem.vce has wrong answer !
0
0
OSPF is not used since 2008.
0
0
I think the mask should be 255.255.255.255… Not shure.
0
0
Normally (at list in the cisco world) when using a mask for routing a whildcard subnet mask is used. Hence the 0.0.0.0
0
0
Sorry I replied with rubbish ^^
0.0.0.0/32 would mean that anything addressed to specific IP 0.0.0.0 ONLY would be routed to Server 2. 0.0.0.0/0 Would effectively be super netting every IP to Server 2.
0
0
The answer is correct, but who would ever do this. Wouldn’t you just put your routers in a failover or loadbalancing mode?
0
0
Remember, this is MicrosoftWorld.
Microsoft doesnt take into account other companies capabilities… like I doubt Microsoft cares what Cisco does with their routers and how they are configured.
All of these M$ exams are built around how you should run a 100% Microsoft network. It’s really stupid.
1
0