Scenario:
You are the senior network security administrator for your organization. Recently and junior
engineer configured a site-to-site IPsec VPN connection between your headquarters Cisco ASA
and a remote branch office.
You are now tasked with verifying the IKEvl IPsec installation to ensure it was properly
configured according to designated parameters. Using the CLI on both the Cisco ASA and
branch ISR, verify the IPsec configuration is properly configured between the two sites.
NOTE: the show running-config command cannot be used for this exercise.
Topology:

In what state is the IKE security association in on the Cisco ASA?

A.
There are no security associations in place

B.
MM_ACTIVE

C.
ACTIVE(ACTIVE)

D.
QM_IDLE

Explanation:
This can be seen from the “show crypto isa sa” command: