Your network contains an Active Directory domain named contoso.com. The domain contains three
servers named Server1, Server2, and Server3 that run Windows Server 2012 R2. All three servers
have the Hyper-V server role installed and the Failover Clustering feature installed.
Server1 and Server2 are nodes in a failover cluster named Cluster1. Several highly available virtual
machines run on Cluster1. Cluster1 has that Hyper-V Replica Broker role installed. The Hyper-V
Replica Broker currently runs on Server1.
Server3 currently has no virtual machines.
You need to configure Cluster1 to be a replica server for Server3 and Server3 to be a replica server
for Cluster1.
Which two tools should you use? {Each correct answer presents part of the solution. Choose two.)

A.
The Hyper-V Manager console connected to Server3

B.
The Failover Cluster Manager console connected to Server3

C.
The Hyper-V Manager console connected to Server1.

D.
The Failover Cluster Manager console connected to Cluster1

E.
The Hyper-V Manager console connected to Server2

Explanation:
Steps:
Install the Replica Broker Hyper-v “role” configure replication on Server 3 in Hyper-V manager and
mention the cluster (that’s why a replica broker is needed) configure replication on Cluster 1 using
the failover cluster manager.
Using Hyper-V Replica in a failover cluster The configuration steps previously described Apply to VMs
that are not hosted in a failover cluster. However, you might want to provide an offsite replica VM
for a clustered VM. In this scenario, you would provide two levels of fault tolerance. The failover
cluster is used to provide local fault tolerance, for example, if a physical node fails within a
functioning data center. The offsite replica VM, on the other hand, could be used to recover only
from sitelevel failures, for example, in case of a power outage, weather emergency, or natural
disaster. The steps to configure a replica VM for a clustered VM differ slightly from the normal
configuration, but they aren’t complicated. The first difference is that you begin by opening Failover
Cluster Manager, not Hyper-V Manager. In Failover Cluster Manager, you then have to add a failover

cluster role named Hyper-V Replica Broker to the cluster. (Remember, the word “role” is now used
to describe a hosted service in a failover cluster.) To add the Hyper-V Replica Broker role, right-click
the Roles node in Failover Cluster Manager and select Configure Role. This step opens the High
Availability Wizard. In the High Availability Wizard, select Hyper-V Replica Broker