— Exhibit — In the exhibit, R2 has a failure and R6 is promoted from the BDR to the DR. Which router is elected as the new BDR?
A. R1
B. R3
C. R4
D. R5
3 Comments on “Which router is elected as the new BDR?”
Lavrovosays:
priority 0 means don’t participate
priority 1 is the lowest one
Priority 128 is the default
Priority 255 is the highest
0
0
dnxsays:
La respuesta es la D (R5).
Existen dos criterios para definir el DR y el BDR:
1er criterio: La prioridad, este va de 0 a 255, el que tiene una mayor prioridad es el elegido, la prioridad por defecto si no menciona es 128. Prioridad 0, significa que no puede ser elegido como DR o BDR.
2do criterio: El RID, a mayor RID mejor (numéricamente hablando).
Nota: Entre la prioridad y el RID, se debe considerar a la prioridad como la función que define el DR y BDR.
0
0
Ryansays:
translate:
There are two criteria for defining the DR and BDR:
1st criterion: The priority, this goes from 0 to 255, which has a higher priority is chosen, the default priority if not mentioned is 128. Priority 0, means it can not be elected as DR or BDR.
The 2nd criterion: The RID, the higher RID better (numerically speaking).
Note: Both the priority and RID should be considered a priority as the function defining the DR and BDR.
priority 0 means don’t participate
priority 1 is the lowest one
Priority 128 is the default
Priority 255 is the highest
0
0
La respuesta es la D (R5).
Existen dos criterios para definir el DR y el BDR:
1er criterio: La prioridad, este va de 0 a 255, el que tiene una mayor prioridad es el elegido, la prioridad por defecto si no menciona es 128. Prioridad 0, significa que no puede ser elegido como DR o BDR.
2do criterio: El RID, a mayor RID mejor (numéricamente hablando).
Nota: Entre la prioridad y el RID, se debe considerar a la prioridad como la función que define el DR y BDR.
0
0
translate:
There are two criteria for defining the DR and BDR:
1st criterion: The priority, this goes from 0 to 255, which has a higher priority is chosen, the default priority if not mentioned is 128. Priority 0, means it can not be elected as DR or BDR.
The 2nd criterion: The RID, the higher RID better (numerically speaking).
Note: Both the priority and RID should be considered a priority as the function defining the DR and BDR.
0
0