How should the FastEthernet0/1 port on the 2950 model switches that are shown in the exhibit be configured to
Refer to the exhibit. How should the FastEthernet0/1 port on the 2950 model switches that are shown in the exhibit be configured to allow connectivity between all devices?
What action could the network administrator take to prevent access by multiple laptops through a single switch
Refer to the exhibit. Some 2950 series switches are connected to the conference area of the corporate headquarters network. The switches provide two to three jacks per conference room to host laptop connections for employees who visit the headquarters office. When large groups of employees come from other locations, the network administrator often finds that hubs have been connected to wall jacks in the conference area although the ports on the access layer switches were not intended to support multiple workstations.
What action could the network administrator take to prevent access by multiple laptops through a single switch port and still leave the switch functional for its intended use?
What two functions will occur when this frame is received by 2950Switch?
Refer to the exhibit. The following commands are executed on interface fa0/1 of 2950Switch.
2950Switch(config-if)# switchport port-security
2950Switch(config-if)# switchport port-security mac-address sticky
2950Switch(config-if)# switchport port-security maximum 1
The Ethernet frame that is shown arrives on interface fa0/1. What two functions will occur when this frame is received by 2950Switch? (Choose two.)
What commands must be configured on the 2950 switch and the router to allow communication between host 1 and h
Refer to the exhibit. What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)
which switch will be elected as the root bridge?
Refer to the exibit. Three cisco 2950 switches are set to their default priority settings.During the spanningtree process,which switch will be elected as the root bridge?
What steps will ensure that the old configuration is erased?
A Catalyst 2950 needs to be reconfigured. What steps will ensure that the old configuration is erased? (Choose three.)
What must be done to ensure that this new switch becomes the root bridge on the network?
The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 2950 series switch. What must be done to ensure that this new switch becomes the root bridge on the network?
Which two commands must the network administrator configure on the 2950 Catalyst switch to meet this policy?
The network security policy requires that only one host be permitted to attach dynamically to each switch interface. If that policy is violated, the interface should shut down. Which two commands must the network administrator configure on the 2950 Catalyst switch to meet this policy? (Choose two.)
which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet
The switches shown in the diagram, Core and Core2, are both Catalyst 2950s. The addressing scheme for each company site is as follows:
Router Ethernet port – 1st usable address
Core – 2nd usable address
Core2 – 3rd usable address
For this network, which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet on the network? (Choose three.)