Refer to the exhibit. How should the FastEthernet0/1 port on the 2950 model switches that are shown in the exhibit be configured to allow connectivity between all devices?
A.
The ports only need to be connected by a crossover cable.
B.
SwitchX(config)# interface FastEthernet 0/1
SwitchX(config-if)# switchport mode trunk
C.
SwitchX(config)# interface FastEthernet 0/1
SwitchX(config-if)# switchport mode access
SwitchX(config-if)# switchport access vlan 1
D.
SwitchX(config)# interface FastEthernet 0/1
SwitchX(config-if)# switchport mode trunk
SwitchX(config-if)# switchport trunk vlan 1
SwitchX(config-if)# switchport trunk vlan 10
SwitchX(config-if)# switchport trunk vlan 20
SwitchX(config-if)# switchport trunk vlan 20
I have the same idea.
0
0
response A. remaining will make DTP
0
0