Exhibit, Output
Which prefix-list can be used to permit only the 192.168.12.0/22 and the 192.168.20.0/22
prefixes?

Exhibit

What does the route map in the exhibit accomplish? Select three.

When nonadjacent LDP neighbors are used for implementing an MPLS traffic engineering
solution, how are the nonadjacent LDP neighbors discovered?

DRAG DROP
Look at the picture.
Drag and drop the correct commands in the proper order to redistribute the RED VPN routes from the EIGRP vrf into the BGP vrf.

Refer to the exhibit. Based on the show outputs, which condition could be preventing the P1 router
from
establishing TDP adjacency with its neighbor over the s0/0.211 and s0/0.212 subinterfaces?

With MPLS VPNs, if the CE-PE routing protocol is BGP, which statement below is true?

DRAG DROP
Look at the picture.
Drag the item on the left to the correct table it pertains to on the right.

BGP is used as the CE-PE routing protocol in an MPLS VPN. The customer routes are
successfully
propagated from the CE router to the ingress PE router, but they are not showing up on the egress
PE router.

What is the most likely cause of the problem?

Refer to the exhibit. A diagram of a router connected to an MPLS-enabled ATM switch via an LCATM MPLS interface, and a partial configuration for the MPLS-enabled ATM switch and router are
shown. Which statement describes what is incorrect about the configuration shown?
Exhibit:

Refer to the exhibit. A diagram of a router connected to an MPLS-enabled ATM switch via an LCATM MPLS interface, and the partial configuration for the MPLS-enabled ATM switch and router
are shown. Which statement describes what is incorrect about the configuration?
Exhibit: