What is wrong with the following MP-BGP to EIGRP route redistribution configuration?
What is wrong with the following MP-BGP to EIGRP route redistribution configuration?
router eigrp 100
address-family ipv4 vrf XYZ
autonomous-system 200
redistribute bgp 51001
Which statement correctly describes managed CE routers service?
Which statement correctly describes managed CE routers service?
Drag the term on the left to its description on the right. Not al the terms on the left are used.
Which statement represents the overall impact of convergence in a frame-mode MPLS network when there is a fail
Which statement represents the overall impact of convergence in a frame-mode MPLS network
when there is a failure on a link that an LSP is using?
Which three statements correctly describe how labels are used in cell-mode MPLS?
Which three statements correctly describe how labels are used in cell-mode MPLS? (Choose
three.)
what will happen if an LSR receives an incoming labeled packet but the LSR can’t find that incoming labe
When using MPLS unicast IP forwarding, what will happen if an LSR receives an incoming labeled
packet but the LSR can’t find that incoming label in its LFIB?
What is the purpose of the area {area-id} sham-link {source-address} {destination-address} cost {number} comma
What is the purpose of the area {area-id} sham-link {source-address} {destination-address} cost
{number}
command?
Which two of the following describe the actions that the OSPF routing process on a PE router will take based o
Which two of the following describe the actions that the OSPF routing process on a PE router will
take based on the down bit being set? (Choose two.)
What is a problem that can cause this issue?
The following partial output is a PE router configuration related to the OSPF process. During
troubleshooting, you notice that the OSPF routes from the remote sites are not showing up in the
local CE router. What is a problem that can cause this issue?router ospf 1 vrf ABC network 0.0.0.0
255.255.255.255 area 0 redistribute bgp 55111
Which parameter(s) will the OSPF RT:0:1:0 indicate?
An OSPF route is redistributed into MP-BGP with the following extended community: Extended
Community: RT:1:10 OSPF RT:0:1:0 Which parameter(s) will the OSPF RT:0:1:0 indicate?