PrepAway - Latest Free Exam Questions & Answers

Category: 350-401

Exam 350-401: Implementing Cisco Enterprise Network Core Technologies (ENCOR)

Which of the following commands should you issue from policy-map class configuration mode? (Select the best an

You are creating a policy map for VoIP packets. VoIP packets must receive 30 percent of the bandwidth on the S0/0 interface. Jitter and delay should be minimized. Which of the following commands should you issue from policy-map class configuration mode? (Select the best answer.) A. priority 30 B. priority percent 30 C. bandwidth 30 […]

Which of the following statements are true regarding Cisco PfR? (Select 2 choices.)

Which of the following statements are true regarding Cisco PfR? (Select 2 choices.) A. Active mode generates probes for all exit paths. B. Passive mode generates probes for all exit paths. C. Active mode monitors delay, packet loss, throughput, and reachability. D. Both active mode and passive mode monitor reachability and delay. E. Active mode […]

Switch1 and Switch2 are configured as a VSS. Switch1 has a higher priority. Switch2 has a higher switch ID. Bo

Switch1 and Switch2 are configured as a VSS. Switch1 has a higher priority. Switch2 has a higher switch ID. Both switches are started simultaneously. Which of the following will occur if RRP discovers an incompatibility between the switches? (Select the best answer.) A. Both switches will come up in RPR mode. B. Both switches will […]

Which of the following commands can you issue to enable RSTP? (Select 2 choices.)

Which of the following commands can you issue to enable RSTP? (Select 2 choices.) A. spanning-tree mode mst B. spanning-tree mode pvst C. spanning-tree mode rapid-pvst D. no spanning-tree mode Explanation: You can issue the spanning-tree mode mst command or the spanning-tree mode rapid-pvst command to enable Rapid Spanning Tree Protocol(RSTP). RSTP, which is defined […]

You administer several switches on a network. The switches are configured with the default MLD snooping settin

You administer several switches on a network. The switches are configured with the default MLD snooping settings. Several VLANs are configured on each switch. Which of the following statements is most accurate? (Select the best answer.) A. The switches will not forward IPv6 multicast traffic. B. The switches will forward IPv6 multicast traffic to every […]

Which of the following partial output from the show ip cache flow command would you expect to see for an HTTP

Which of the following partial output from the show ip cache flow command would you expect to see for an HTTP connection sent from 10.1.1.36? (Select the best answer.) A. SrcIF SrcIPaddress DstIf DstIPaddress Pr SrcP DstP PktsEt0/0 10.1.1.36 Et1/0 10.2.1.74 06 C486 0050 1 B. SrcIF SrcIPaddress DstIf DstIPaddress Pr SrcP DstP PktsEt0/0 10.1.1.36 […]


Page 1 of 3123