which of the following 1000V characteristics can the designer take advantage of?
Refer to the exhibit.
The Cisco Nexus 1000V in the VMware vSphere solution effectively creates an additional access
layer in the virtualized data center network; which of the following 1000V characteristics can the
designer take advantage of?
Which two commands will you use to replace the existing commands?
You have the followings commands on your Cisco Router:
ip ftp username admin
ip ftp password backup
You have been asked to switch from FTP to HTTP. Which two commands will you use to replace the
existing commands?
which of the following?
Support of vPC on the Cisco Nexus 5000 access switch enables various new design options for
the data center Access layer, including which of the following?
Which commands will you use to configure the router?
You have 2 NTP servers in your network – 10.1.1.1 and 10.1.1.2. You want to configure a Cisco router
to use 10.1.1.2 as its NTP server before falling back to 10.1.1.1. Which commands will you use to
configure the router?
which one of the following solutions?
The requirement for high availability within the Data Center network may cause the designer to
consider which one of the following solutions?
Which alerts will be seen on the console?
The following command is issued on a Cisco Router:
Router(configuration)#logging console warnings
Which alerts will be seen on the console?
which of the following should the designer consider?
When designing remote access to the Enterprise Campus network for teleworkers and mobile
workers, which of the following should the designer consider?
Which two of the following options are categories of Network Maintenance tasks?
Which two of the following options are categories of Network Maintenance tasks?
Which of the following is most accurate with respect to designing high availability within the Enterprise Camp
Which of the following is most accurate with respect to designing high availability within the
Enterprise Campus network?
Which layer of the OSI model does the problem most likely exist?
You enabled CDP on two Cisco Routers which are connected to each other. The Line and Protocol
status for the interfaces on both routers show as UP but the routers do not see each other a CDP
neighbors. Which layer of the OSI model does the problem most likely exist?