What will the debug output on the console show?
The following commands are issued on a Cisco Router:
Router(configuration)#access-list 199 permit tcp host 10.1.1.1 host 172.16.1.1
Router(configuration)#access-list 199 permit tcp host 172.16.1.1 host 10.1.1.1
Router(configuration)#exit
Router#debug ip packet 199
What will the debug output on the console show?
What level of logging is enabled on a Router where the following logs are seen?
What level of logging is enabled on a Router where the following logs are seen?
%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up
Which two commands will you use to replace the existing commands?
You have the followings commands on your Cisco Router:
ip ftp username admin
ip ftp password backup
You have been asked to switch from FTP to HTTP. Which two commands will you use to replace the
existing commands?
Which commands will you use to configure the router?
You have 2 NTP servers in your network – 10.1.1.1 and 10.1.1.2. You want to configure a Cisco router
to use 10.1.1.2 as its NTP server before falling back to 10.1.1.1. Which commands will you use to
configure the router?
Which alerts will be seen on the console?
Which two of the following options are categories of Network Maintenance tasks?
Which two of the following options are categories of Network Maintenance tasks?
Which layer of the OSI model does the problem most likely exist?
You enabled CDP on two Cisco Routers which are connected to each other. The Line and Protocol
status for the interfaces on both routers show as UP but the routers do not see each other a CDP
neighbors. Which layer of the OSI model does the problem most likely exist?
which of the following?
FCAPS is a network maintenance model defined by ISO. It stands for which of the following?
Which three management categories are contained in the FCAPS network maintenance model?
Which three management categories are contained in the FCAPS network maintenance model?
(Choose three.)
What is the result of configuring the logging console warning command?
What is the result of configuring the logging console warning command?