Refer to the exhibit.
The link aggregation is failing between the HP Provision and HP Comware switches. Which solution solves this
problem?
A.
configuring contiguous interfaces, such as 10 and 11, in the ProVision link aggregation (trk 10)
B.
removing the ProVision interfaces from trk10 and assigning them to trk1 instead
C.
configuring the Comware switch to use dynamic link-aggregation mode on the bridge aggregation interface
D.
removing the VLAN assignment from the Comware bridge aggregation interface and configuring the
assignment on the physical interfaces
correct, comware by default uses so called manual bridge aggregation, no LACP used.
Exhibit is not shown above but it pictures provision Trk10 port using LACP
0
0