Refer to the exhibit.
The exhibit shows the IP routing table for an HP Provision switch. The network administrator then enters these
commands:
What is the result of this configuration?
A.
All four routes are added to the routing table, but are never used.
B.
The switch only adds the last two static route entries to the routing table.
C.
The switch load shares connections across the four static next hops.
D.
The switch only adds the last static route entry to the routing table.
I’m must admit I’m a bit lost here. I thought all of them would be installed,
equal-cost multi-path (ECMP) load sharing.
I’m not sure though as on the exhibit there’s gateway on vlan 100 and vlan 11 for the single ip route entry – I’m lost
0
0