A port on an HP Provision switch currently has its default VLAN assignment. The network administrator wants
the port to continue to be part of the default VLAN. The administrator also wants the port to support VLANs 2
and 3.
What should the administrator do to accomplish this?
A.
Add VLAN 2 to the port as an untagged VLAN assignment and VLAN 3 as a tagged assignment.
B.
Add VLANs 2 and 3 to the port as tagged VLAN assignments.
C.
Add VLANs 2 and 3 to the VLAN permit list for the port
D.
Add the port to hybrid VLAN 2 and 3.
B is correct cos:
1. there is no such thing as hybrid ports on procurve (comware only)
2. you permit vlans on comware, on procurve as per the below
ProCurve Switch 2650-PWR(config)# vlan ?
VLAN-ID Enter VLAN identifier or name for the ‘vlan’
command/parameter.
ProCurve Switch 2650-PWR(config)# vlan 2 ?
forbid Prevent ports from becoming a member of the current
VLAN.
ip Configure various IP parameters for the VLAN.
name Set the VLAN’s name.
qos Set VLAN-based priority.
tagged Assign ports to current VLAN as tagged.
untagged Assign ports to current VLAN as untagged.
ProCurve Switch 2650-PWR(config)# vlan 2 tagged ?
[ethernet] PORT-LIST Enter a list of ports or one port for the ‘tagged’
command/parameter.
ProCurve Switch 2650-PWR(config)# vlan 2 tagged ethernet ?
PORT-LIST Enter a list of ports or one port for the ‘ethernet’
command/parameter.
ProCurve Switch 2650-PWR(config)# vlan 2 tagged ethernet 1 ?
3. if you follow the steps from A and add port to vlan 2 as untagged it will be removed from vlan 1. I did it on 2960 switch, used port 1, see the below result:
ProCurve Switch 2650-PWR(config)# show run
…
hostname “ProCurve Switch 2650-PWR”
snmp-server community “public” Unrestricted
vlan 1
name “DEFAULT_VLAN”
untagged 2-50
ip address dhcp-bootp
no untagged 1
exit
vlan 2
name “VLAN2”
tagged 1
exit
vlan 3
name “VLAN3”
untagged 1
exit
0
0