After proper cabling, enabling the FC ports on the initiator and target, and creating a LIF within a
Vserver, you still are not able to see the initiator using the Vserver fcp initiator show command.
What is the likely cause?
A.
The initiator and target are not properly zoned on the Fibre Channel switch.
B.
The initiator is probably coming over an indirect path and this command does not display
initiator over indirect paths.
C.
The initiator will not appear until a LUN is mapped to Igroup within the Vserver
D.
The Initiator will not appear until you create a LUN within the Vserver.
Explanation:
I think the right answer is A
You can see the initiator “logged in” in a FC adapter also if you don’t create a lun by the “fcp show initiator”
0
0
I think you are correct. A is the answer
0
0
Agreed. Correct answer is A.
0
0
Agreed. “A”
0
0
I have the same idea. D
0
0