HOTSPOT
You have an Exchange Server 2016 organization. The Active directory sites are configured as shown in the
following graphic.
Use the drop-down menus to select the answer choice that completes each statement based on the information
presented in the graphic.
Hot Area:
Answer: 
Explanation:
http://blogs.technet.com/b/exchange/archive/2006/09/15/3394889.aspx
Wrong.
Site 2 / Site 2. Look at the cost of the routes.
https://technet.microsoft.com/en-us/library/jj916681(v=exchg.160).aspx
4
0
OK with Stillme
1
0
I agree
0
0
Site 2 / Site 1
http://techgenix.com/exchange-2013-mail-flow-part2/
Exchange 2013 uses the same logic as Exchange 2010 to select the routing path for a message:
1- Calculate the least-cost routing path by adding the cost of the IP site links that must be traversed to reach the destination. If the destination is a connector, the cost assigned to the address space is added to the cost to reach the selected connector. If multiple routing paths are possible, the routing path with the lowest aggregate cost is used;
2- If more than one routing path has the same cost, the routing path with the least number of hops is used;
3- If more than one routing path is still available, the name assigned to the AD sites before the destination is considered. The routing path where the AD site nearest the destination is lowest in alphanumeric order is used. If the site nearest the destination is the same for all routing paths being evaluated, an earlier site name is considered.
1
1
Did not notice Hub site earlier.
Right Answer: Site 2 / Site 2
1
0
Site 2 is a hub site and is on a equal cost route as Site3 .. but Site 3 is not hub site ..So Site 2 leads and is perfect answer .
0
0