What are two [2] steps required to perform this migration?
Your customer has three fabric islands. One fabric island has three ED-1032s. Two other fabric
islands have two DS16B2s in each. The customer wants to migrate to two fabrics built of two MDS
9509s in each fabric. Several SUN Solaris servers must be migrated on-line to the new fabrics.
What are two [2] steps required to perform this migration?
What do you tell your customer?
Your customer is collapsing their complex MDS core-edge fabric environment. Several ISLs and
VSANs have been implemented to route traffic away from fabric nodes. These fabric nodes will be
retired. The customer is concerned about disruptive RSCNs crossing the entire fabric while these
changes are made. What do you tell your customer?
Which configuration file should be modified?
Customer is implementing HP-UX MC/ServiceGuard. They are having problems getting the cluster
nodes to see EMC storage. The cluster lock disk needs to be entered into a configuration file.
Which configuration file should be modified?
What is the maximum bandwidth for a T3 circuit?
The customer has decided to create an SRDF environment, extending the existing fabric
approximately 500 kilometers using FCIP. What is the maximum bandwidth for a T3 circuit?
which product would allow for the IP SAN connectivity?
What are the steps to migrate the fabrics without recreating the zones?
Your customer has two SAN islands built with two ED64Ms in each fabric. Due to the end of the
lease these are being replaced with ED-12000Bs. What are the steps to migrate the fabrics
without recreating the zones?
Why do you enable the 10/100Km flag for the four ISL ports on each director in the diagram?
What do you advise the customer to do?
There are 12 Solaris hosts connected to two fabrics and a DMX2000. All the hosts are dual-pathed
using Emulex HBAs. All 12 HBAs in each fabric are connected and zoned to one FA port. Each
host is doing 2000 IOPS. Each I/O size is 64KB. Two of the hosts are receiving the following error
in their /var/adm/messages file: SCSI transport failed: reason ‘timeout’: retrying command What do
you advise the customer to do?
Which Connectrix B-series routing policies should be used?
Customer requires dynamic SAN routing and load balancing across multiple links. Which
Connectrix B-series routing policies should be used?