What is the maximum amount of additional throughput that can be added to the two switches combined together?
You are monitoring two DS 32B switches. You have produced the WLA
graph for one of the switches. The WLA graph from the second switch is identical. All ports are
operating at 1Gb/s. What is the maximum amount of additional throughput that can be added to
the two switches combined together?
What happens in this environment if a link fails in a port-channel group?
The customer is implementing a full-mesh fabric with four 9506 MDS Connectrix Directors. Each
director in the mesh will be connected with dual connection port channels to a neighboring switch,
giving the fabric a cost of 250 between each director. The hosts in the environment must pass
through two directors to access storage, with an aggregate link cost from the host to the storage of
500. What happens in this environment if a link fails in a port-channel group?
Which command would have prevented this?
Your customer is upgrading the firmware on their MDS switch. After the upgrade the connected
HP-UX and AIX Servers are unable to see their devices. Which command would have prevented
this?
What could to be done to the SAN to eliminate this problem?
What has happened?
The customer is preparing the B-series SAN environment to eliminate the presence of edge SAN
devices. The administrator has manipulated the Core-PID format on all edge switches to be of
unique value. Without realizing the impact of change, the attached HP-UX servers have
subsequently lost access to their SAN devices. What has happened?
you need to configure?
What is the total number of ISL ports required?
A customer wants to merge eight single DS-32B2 fabrics in a full mesh fabric. What is the total
number of ISL ports required?
What are the four [4] steps to do this?
You are creating an FCIP configuration. The Fibre Channel Routing has been enabled on each
Multi-protocol Router and verified as working. Now the FCIP link between the two Routers can be
brought up. What are the four [4] steps to do this?
Which FCC policy definition must be enabled so that Alerts are sent to the console whenever such differences o
Customer is using ControlCenter Policy definitions to monitor and manage their fabric. Customer
has expressed concerns that there are often differences between what is reported in
ControlCenter and the switches. Which FCC policy definition must be enabled so that Alerts are
sent to the console whenever such differences occur?
Why is the IQN not working?
The customer has modified the IQNs on some of their Windows 2000 servers connected to a CX-600. Now they can not see any of the devices. The name they tried to use was: 1992-04.com.CustomerToBeNamedAtALaterDate:::::.com Why is the IQN not working?