Refer to the exhibit.
A deployment engineer is setting up SC4020. The engineer turns on the system. Both controllers initialize to
SafeMode and are ready for configuration. The engineer plugs serial cable into first controller and types
“platform prejoin show”. The output is as shown.
What are two reasons that the deployment will fail if the engineer continues configuring this controller? (Choose
The engineer has serial cable plugged into the bottom controller and needs to be plugged into the top
The eth1 IPv4 IP address was used at the factory to load firmware and was NOT cleared out before
The controller chassis is installed upside down in the rack.
The engineer has serial cable plugged into the top controller and needs to be plugged into the bottom