To allow or prevent load balancing to network 172.16.3.0/24, which of the following commands
could be used in R2? (Choose two.)

A.
R2(config-if)#clock rate

B.
R2(config-if)#bandwidth

C.
R2(config-if)#ip ospf cost

D.
R2(config-if)#ip ospf priority

E.
R2(config-router)#distance ospf

Explanation:
OSPF Cost
http://www.cisco.com/en/US/tech/tk365/technologies_white_paper09186a0080094e9e.shtml#t6

The cost (also called metric) of an interface in OSPF is an indication of the overhead required to send
packets across a certain interface. The cost of an interface is inversely proportional to the bandwidth
of that interface. A higher bandwidth indicates a lower cost. There is more overhead (higher cost)
and time delays involved in crossing a 56k serial line than crossing a 10M ethernet line. The formula
used to calculate the cost is: cost= 10000 0000/bandwith in bps For example, it will cost 10 EXP8/10
EXP7 = 10 to cross a 10M Ethernet line and will cost 10 EXP8/1544000 =64 to cross a T1 line. By
default, the cost of an interface is calculated based on the bandwidth; you can force the cost of an
interface with the ip ospf cost <value> interface subconfiguration mode command.