If required, what password should be configured on the DeepSouth router in the branch office to
allow a connection to be established with the MidEast router?
A.
No password is required.
B.
Enable
C.
Secret
D.
Telnet
E.
Console
Explanation:
In the diagram, DeepSouth is connected to Dubai’s S1/2 interface and is configured as follows:
Interface Serial1/2 IP address 192.168.0.5 255.255.255.252 Encapsulalation PPP ; Encapsulation for
this interface is PPP
Check out the following Cisco Link:
http://www.cisco.com/en/US/tech/tk713/tk507/technologies_configuration_example09186a00800
9 4333.shtml#configuringausernamedifferentfromtheroutersname
Here is a snipit of an example:Network Diagram
If Router 1 initiates a call to Router 2, Router 2 would challenge Router 1, but Router 1 would not
challenge Router 2. This occurs because theppp authentication chap callincommand is configured on
Router 1. This is an example of a unidirectional authentication. In this setup, theppp chap hostname
alias-r1command is configured on Router 1. Router 1 uses “alias-r1” as its hostname for CHAP
authentication instead of “r1.” The Router 2 dialer map name should match Router 1’s ppp chap
hostname; otherwise, two B channels are established, one for each direction.
The diagram on this picture seems to be for a different question than the text.
0
0
No password Required
0
0
images/ICND2/Labsim/Frame_Relay_Topology.jpg
0
0
change the names of the bottom routers to Mideast deepsouth Northcentral
0
0
answer should be telnet id you want to connect from one router to other. answer is D
0
0
and not telnet but answer should be T1net if to look at show run output
0
0
but if its up to link connection ppp between two routers and if one side has set up of unidirectional ppp chap then on other side no deed for password
0
0
Obviously this has to be en PPP encapsulation, if asked for a posible password for SOUTH_ROUTER you pick c0nsol3, and for NORTH_ROUTER you pick t31net. If you’re running HDLC, i would pick “no password is required”
0
0