What is causing this problem?
Refer to the show outputs in the exhibit. R1 is using a route-map to perform AS-path prepending for only a set of prefixes. When the route-map is applied, R1 only sends the prefixes with the AS-path prepended. All other prefixes in the BGP table are no longer advertised out to the BGP neighbor.What is causing this problem?
Exhibit:
What are two reasons why the 197.1.0.0/16 and 192.168.1.0/30 prefixes are not in the BGP table of WGR1?
Refer to the BGP configurations and the show outputs in the diagram. What are two reasons why the 197.1.0.0/16 and 192.168.1.0/30 prefixes are not in the BGP table of WGR1? (Choose two.)
Exhibit:
which is the correct configuration?
Refer to the exhibit. Service provider A (AS 123) has an EBGP session to Certkiller where the AS number 65053 is used at Certkiller ‘s end. Service provider B (AS 234) also has an EBGP session to Certkiller where the AS number 65286 is used at Certkiller ‘s end. The customer decides to use AS 65053 internally. All router BGP configuration lines have 65053 as the AS number. The customer uses AS number 65286 only when establishing the EBGP session to AS 234. In this case, which is the correct configuration?
Exhibit:
how many IBGP sessions are required with the Transit AS 51001?
Examine the topology shown above. Within Transit AS 51001, CK3 is setup as a route reflector for CK1 and CK2 , and CK4 is setup as a route reflector for CK5 and CK6 . In this case, how many IBGP sessions are required with the Transit AS 51001? Exhibit:
Which two of these statements are correct?
Refer to the exhibit. Which two of these statements are correct? (Choose two.) Exhibit:
Which two statements are correct?
Refer to the exhibit. Which two statements are correct? (Choose two.) Exhibit:
Which configuration on the ISP edge routers will enable load balancing and backup of the traffic to the custom
In the diagram, the customer is using static routing to connect to the ISP. Which configuration on the ISP edge routers will enable load balancing and backup of the traffic to the customer?
Exhibit:
What effect does the command in the exhibit have?
Exhibit
Certkiller 3(config-router)# neighbor 10.1.1.1 maximum-prefix 100 80 warning-only
What effect does the command in the exhibit have?
Which of these best describe why 21.0.0.0 via the next hop of 2.3.4.5 has been selected as the best path to th
Refer to the exhibit. Which of these best describe why 21.0.0.0 via the next hop of 2.3.4.5 has been selected as the best path to the network? Exhibit:
What should be changed within AS 50001 to improve the route reflector design?
Refer to the diagram. What should be changed within AS 50001 to improve the route reflector design?
Exhibit: