PrepAway - Latest Free Exam Questions & Answers

Category: 640-802

Cisco Certified Network Associate (CCNA®)

What is the problem?

Refer to the exhibit. Two routers have just been configured by a new technician. All interfaces are up. However, the routers are not sharing their routing tables. What is the problem?

What two statements are true of the planned configuration for interface fa0/1?

Refer to the exhibit. A junior network engineer has prepared the exhibited configuration file. What two statements are true of the planned configuration for interface fa0/1? (Choose two.)

What can be concluded from this information?

Refer to the exhibit. The switch in the graphic has a default configuration and the MAC table is fully populated. In addition, this network is operating properly. The graphic represents selected header information in a frame leaving host A. What can be concluded from this information?

In the communication between host 1 and host 2 over the point-to-point WAN, which protocol or technology is re

Refer to the exhibit. In the communication between host 1 and host 2 over the point-to-point WAN, which protocol or technology is represented by dashed line A?

What will happen if host 1 sends a broadcast?

Refer to the exhibit. SW1 and SW2 have default configurations. What will happen if host 1 sends a broadcast?

Based on the partial outputs in the exhibit, what could be the problem?

Refer to the exhibit. From RouterA, a network administrator is able to ping the serial interface of RouterB but unable to ping any of the subnets attached to RouterB. Based on the partial outputs in the exhibit, what could be the problem?

What action does the router take?

Refer to the exhibit. A packet with a source IP address of 192.168.2.4 and a destination IP address of 10.1.1.4 arrives at the HokesB router. What action does the router take?

How will router R2 be affected by the configuration of R1 that is shown in the exhibit?

Refer to the exhibit. Assume that all of the router interfaces are operational and configured correctly. How will router R2 be affected by the configuration of R1 that is shown in the exhibit?

Which two subnetworks would be included in the summarized address of 172.31.80.0 /20?

Which two subnetworks would be included in the summarized address of 172.31.80.0 /20? (Choose two.)

Which network addresses should be used for Link A and Network A?

Refer to the exhibit. All of the routers in the network are configured with the ip subnet-zero command. Which network addresses should be used for Link A and Network A? (Choose two.)


Page 8 of 123« First...678910...203040...Last »