Which network addresses should be used for Link A and Network A?
Refer to the exhibit. All of the routers in the network are configured with the ip subnet-zero command. Which network addresses should be used for Link A and Network A? (Choose two.)
What commands must be configured on the 2950 switch and the router to allow communication between host 1 and h
Refer to the exhibit. What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)
Which (config-router) command will allow the network represented on the interface to be advertised by RIP?
Refer to the exhibit. Which (config-router) command will allow the network represented on the interface to be advertised by RIP?
What is the OSPF default frequency, in seconds, at which a Cisco router sends hello packets on a multiaccess n
What is the OSPF default frequency, in seconds, at which a Cisco router sends hello packets on a multiaccess network?
Which parameter can be tuned to affect the selection of a static route as a backup when a dynamic protocol is
Which parameter can be tuned to affect the selection of a static route as a backup when a dynamic protocol is also being used?
Which statement about this network is true?
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing. OSPF has been configured on the router,as the routing protocol for the network.Which statement about this network is true?
which address range efficiently summarizes the routing table of the addresses for router main?
which address range efficiently summarizes the routing table of the addresses for router main?
Which IP address range meets these requirements?
You are working in a data center environment and are assigned the address range 10.188.31.0/23.You are asked to develop an IP addressing plan to allow the maximum number of subnets with as many as 30 hosts each.Which IP address range meets these requirements?
Which route or routes will the router install in the routing table?
A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?
Which three IP addresses can be assigned to hosts if the subnet mask is /27 and subnet zero is usable?
Which three IP addresses can be assigned to hosts if the subnet mask is /27 and subnet zero is usable? (Choose three.)